Progressive Turf Equipment TD65, Руководство оператора и списки запасных частей

Страница: 13 / 70

TD65
Operator’s Manual
11

Mounting and dismounting tires from rims can be dangerous and
should be performed by trained personnel using correct tools,
equipment and procedures.

Never perform service on a machine that is supported solely by a
jack. Always ensure proper blocking is placed to support load
during service.
Do not support the machine on cinder blocks,
hollow tiles or other members that may fail under
continuous load.
WELDING AND GRINDING WORK PRECAUTIONS
IMPORTANT! A fire extinguisher should be easily accessible
during all welding work.
Welding repairs are to be performed by a trained welder with proper
service instructions. Know the material to be welded and select the
correct welding procedure and materials (electrodes, rods, wire) that
will provide a weld metal strength equivalent to the parent material.
Move the machine to a clean, safe area before welding, grinding or
using a cutting torch on it. This type of work should only be done in a
clean area and not in places that contain combustible liquids, such as
fuel tanks, hydraulic pipes or similar.
Connect arc welder ground as close as possible to work area.
Work with extra care when welding, grinding or torch cutting near
flammable objects.
WORKING ON PAINTED SURFACES
Heated paint gives off poisonous gases. Therefore, paint must be
removed from an area with a radius of at least 4 in (10 cm) before
carrying out welding, grinding, or gas cutting. In addition to the health
hazard, the weld will be of inferior quality and strength if the paint is not
removed.
WORKING ON GALVANIZED / PLATED SURFACES
Only qualified welders should attempt a weld repair on galvanized or
plated components. Proper pre-welding surface preparation is
required.
Always ensure proper ventilation, wear proper respiratory protective
equipment and avoid direct contact with smoke emitted from welding
process.