Progress PHN 1310, Инструкция пользователя

Страница: 17 / 76

17 progress
7. Use the bolts to remove the inner panels.
8. Turn both locking screws by 90° and
remove them.
9. Carefully lift the top panel slightly and
remove the panel which is framed on all 4
sides by an ornamental border.
Clean the oven door with luke-warm water
and a soft cloth. Do not use metal pads, metal
wool, abrasive pads or acids to clean the oven
door as they will damage the special heat-
reflective surfaces of the inner panels.
After cleaning the inner panels, re-insert them
in the door. Refit the oven door; to do so,
repeat the above sequence in reverse. Ensure
the panels are the right way round.
Then, proceed as follows:
a) The inner panel with the frame on 4 sides
must be inserted so that the printing on
the screen is facing to the outside of the
oven. You will know the panel is properly
in place if, when you touch the visible
surface with your fingers, it doesn’t feel
rough where the printing is.
The inner panel must be inserted in positionas
shown in the diagram. After inserting the
panel in the oven door, fix in position as
described under point 8.
Never clean the oven door when
it is warm as the panels might
shatter. If you can see scratches
or cracks in the glass panel, call
your nearest service centre
immediately to have the panel
replaced.
)
90°
1
2