Progress PG0853, Руководство пользователя

Страница: 35 / 52

Problem Possible cause Solution
The water drainage plug is
not correctly positioned. Position the water drainage
plug in the correct way.
Food products are not wrap-
ped properly. Wrap the food products bet-
ter.
Temperature is set incorrect-
ly. Refer to "Operation" chapter.
The compressor does not
start immediately after press-
ing the , or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
The temperature in the appli-
ance is too low/too high. The temperature regulator is
not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tempera-
ture is too high. Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are stor-
ed at the same time. Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
The door has been opened
often. Open the door only if neces-
sary.
There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
INSTALLATION
WARNING!
Refer to Safety
chapters.
Location
Refer to the assembly
instructions for the installation.
Progress 35