Service
• To repair the appliance contact an
Authorised Service Centre.
• Use original spare parts only.
Disposal
WARNING! Risk of injury or
suffocation.
• Contact your municipal authority for
information on how to discard the
appliance correctly.
• Disconnect the appliance from the
mains supply.
• Cut off the mains electrical cable close
to the appliance and dispose of it.
INSTALLATION
WARNING! Refer to Safety
chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable,
use the cable type: H05V2V2-F which
withstands a temperature of 90°C or
higher. Speak to your local Service
Centre.
Attaching the seal - Integrated
instllation
1. Clean the rabbets in the worktop.
2. Cut the supplied 3x10mm seal stripe
into 4 stripes. The stripes must have
the same length as the rabbets.
3. Cut the ends of the stripes at an angle
of 45°. They should fit in the corners of
the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not stretch the stripes. Do not bond the
ends of the stripes one over the other.
After you assemble the hob, seal the
remaining gap between the glass ceramic
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
Assembly
min.
50mm
min.
500mm
6 Progress
