Progress Lighting AirPro 785247248797, Руководство по установке, Страница: 7 / 42

4.
Hanging the Fan
REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 5.
Step 3.
Remove the 5 motor screws
preassembled at the bottom of motor
assembly,discarding the screws and the
preassembled shipping blocks. (Fig.6)
Step 2. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 4. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly. (Fig. 7)
Step 5. Route wires exiting from the top of
the fan motor through the coupling cover,
decorative cover, canopy and then through the
downrod. (Fig. 8)
Step 6. Align the holes at the bottom of the
downrod with the holes in the collar on
top of the motor housing (Fig. 8). Carefully
insert the hanger pin through the holes in
the collar and downrod. Becareful not to
jam the pin against the wiring inside the
downrod. Insert the lock pin through the hole near the
end of the hanger pin until it snaps into its locked
position, and tighten set screws as shown in Fig.8. Cut
off excess fixture wires leaving approximately 6 to 9
inches above top of hanger ball/downrod assembly.
Ceiling hanger
bracket
Set screw
Downrod/ball assembly
6 to 9in
Motor assembly
Motor
assembly
Hanger ball
Hanger pin
Downrod
Canopy
Decorative
cover
Coupling cover
Hanger pin
Lock
pin
Lock pin
Motor
screw
UL Listed
electrical box
Washers
Shipping
block
Mounting screws
(supplied with
electrical box)
120V wires
Figure 5
Figure 6
Figure 7
Figure 8
WARNING
FAILURE TO PROPERLY INSTALL
LOCK PIN AS NOTED IN STEP 6
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.