Disassembly & Assembly and Cleaning of Main Brush
1.Disassembly of Main Brush
1).Clasp the two spring buckles beside the main brush, and raise the cover, refer to
P3-13.
2).Lift up the right side of main brush and then pull it out rightward. Take out the two
brushes in turn, refer to P3-14.
Clasp these two
spring buckles
to lift up.
P3-13
P3-14
2.Assembly of Main Brush
1).Hold the brush and make the quadrangular side of the shaft to the left refer to P3-15.
2).Insert the quadrangular side of the shaft to the exact left side of upper cover, push
the brush in slightly, then press the right side of shaft into exact position, showed as
P3-16.
3).Close the cover and fasten the buckle, refer to P3-16.
Quadrangular
side in left
P3-15
3.Cleaning of Main Brush
P3-16
Remove the hair and dust on brush so suction inlet can provide greater cleaning efficiency.
1.Clean dirt with cleaning brush, refer to P3-17.
2.Spin the main brush gently to take out hairs and wires, refer to P3-17.
P3-17
15
Pull it to the right
Lift it up first
Insert to
the left
first,
press it
inside then.