REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 26
SERVICE MANUAL
FRONT FRAME RIGIDIZER
FOR JOKER “ZERO”
The configuration with parallel frames (JOKER “ZERO)”, thanks to the
front frame rigidizer, allows for double or flip-up footplates.
You can adjust the rigidizer in height.
Loosen the 4 bolts
A
and the headless bolt
B
on both sides.
Slide the rigidizer up or down. Make sure right and left side are at the
same height and finally fix the 4 bolts
A
first and then the headless bolt
B.
After fixing the bolts
A
, the gap
C
between the two plates of the clamp has
to be the same up/down and front/rear.
With carbon fibre frame do not tighten the headless bolt B
too hard, this may cause serious damage the carbon fi-
bre, up to breakage.
With the V-Design fork support, you can also
fix rigidizer’s supports between the two arms
of the fork supports, unless, in that point,
there is the bolts fixing the footplate tubes.
Should you need to move the rigidizer from
above to within the V-Design, or the other
way round, you need to remove the footplate
tubes, the fork supports and the rigidizer.
Then, reassemble all parts in the wanted
sequence.
In such case, it will be necessary to adjust the front height, see sheet
FRONT HEIGHT ADJUSTMENT 2
–
sliding system V-DESIGN.
A
B
C
