.
3. Foot Pedal Support Bracket and Right
Crank Bolt Installation:
Attach the
Foot Pedal Support Bracket
(18)
onto the right side of the
Right Foot Bar (17)
using
two
Bolts (23)
, two
Washers (24)
, and two
Nylon Nuts (25)
. Use the
Open-Ended Flat Wrench
and
6mm Allen Wrench
to tighten the
Foot Pedal Support Bracket
(18)
to the
Right Foot Bar
(17)
.
Lubricate the
Right Crank Bolt (21)
with some of the
Grease
provided. Insert the
Right Crank
Bolt (21)
and one
Wave Washer (22)
through the right holes of the
Right Foot Bar (17)
. Raise the
rear end of the
Right
Foot Bar (17)
and align it with the threaded hold of the
Right Crank (26)
.
Make sure the
Right Crank Bolt
(21)
is perfectly level and straight as you insert it through the hole
of the
Right Crank (26)
. Turn the
Right Crank Bolt (21)
clockwise
by hand until it is firm. After
hand tightening, completely tighten the
Right Crank Bolt (21)
with the
8mm Allen Wrench
provided. Put one
Spring Washer (27)
and one
Right Nylon Nut (28)
on to the threaded end of the
Right Crank Bolt (21)
. Use the
Open-Ended Wrench
on the
Right Nylon Nut (28)
and the
8mm
Allen Wrench
on the
Right Crank Bolt (21) simultaneously to
tighten the
Right Nylon Nut (28).
Cover the Right
Nylon Nut (28)
with one
Cap (97)
.
Read the note on next page regarding tightening guidelines. Refer to the illustration
showing the correct installation of the Right Crank Bolt (21). See Figure F on the next page.
12
ASSEMBLY
Tools:
6mm Allen
Wrench
Open-Ended
Flat Wrench
8mm Allen
Wrench
Important:
Installing right bolt into right
crank can only be done by
turning right (CLOCKWISE).
R for right bolt
Содержание 300LS
Страница 5: ...LABEL PLACEMENT 3...
Страница 7: ...5 OVERVIEW DRAWING...
Страница 10: ...HARDWARE TOOLS PACK 8...
Страница 11: ...THIS PAGE IS INTENTIONALLY LEFT BLANK 9...