7
10. Loosen the screw to remove the wiring compartment/connection
cover in the rear of the heater.
11. Run the electrical power supply cable in flexible conduit and
connect to the wiring compartment via the knock-out at back side of
the unit.
12. Make the connections properly with connectors which are
suitable for the conductor size, including grounding wirings. And after
making the connections, arrange the pigtail leads of unit and power
supply wires in the wiring compartment.
13 You can use the inside or wall thermostat. If you use the inside
thermostat, press the rock switch to INSIDE THERMOSTAT.
14 If you want to use the wall thermostat (Not included) , press the
rock switch to WALL THERMOSTAT, and insert the two wall
thermostat wire to the Terminal A inside the heater, make sure to
tighten the screws in the Terminal A.
15. Replace the wiring compartment/connection cover and lock in
place with the screw.
