Profoto ProBallast 800, Руководство пользователя, Страница: 14 / 24

ProDaylight 800 Air
14
www.profoto.com
Cooling setting
The Cooling Button [4a] is used to select cooling mode:
• SILENT: “Normal” cooling. In this mode the cooling adapts to the ambient environment,
keeping the noise level to a minimum without risking overheating of the equipment.
• MAX: Maximum cooling is provided for lamp and accessories. This mode is intended
for use only when sound level is not an issue and the lamp is operated under extreme
temperature conditions.
Adjusting light intensity
Use the Setting Knob [6] to adjust the light intensity:
• Turn the Setting Knob [6] clockwise to increase the light intensity in 1% increments and
counter-clockwise to decrease.
• Press and hold down the Setting Knob [6] and turn the knob clockwise to increase the
energy in 10% increments and counter-clockwise to decrease.
Read out firmware version and timer value
To read out the firmware revision and timer value, the lamp must be in standby mode.
1. Press and hold the Setting Knob [6] for 1 second, then release the knob.
2. The timer value in hours will now be displayed.
3. Toggle between the timer value and the firmware revision by turning the Setting Knob
[6] clockwise and counter-clockwise.
4. Reset the timer value by pressing the Channel Set Button [5].
5. Return to standby by pressing the Setting Knob [6].
Changing settings in standby mode
All settings on the lamp can be reached and changed in standby mode. A short press on
the Setting Knob [6] will light up the settings and make it possible to change set values.
Turn unit off
1. Press the On/Off Button [2a] on the ProDaylight 800 Air unit or the Stop Button [D] on
the ProBallast 800to turn off the ProDaylight 800 Air unit.
2. The Power Indicator [2b] on the ProDaylight 800 Air unit will be red, indicating that the
unit is receiving power but is in standby mode.
3. Use the On/Off Switch [A] to turn off the ProBallast 800.
4. Disconnect the AC mains cable on the ProBallast 800 from mains power.