ProForm SPORT 1000, Руководство пользователя

Страница: 9 / 30

9
If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the re-
ceiver and the short jumper wire included with the chest pulse sensor.
3.
Make sure that no wires are pinched.
Reattach the Access Door (94) with the 3/4” Screw (6). The other wires
included with the receiver may be discarded.
1.
Make sure that the power cord is unplugged.
Remove
the indicated 3/4” Screw (6) and the Access Door (94)
from the back of the Console Back (95).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (95). Next, remove the
paper from the adhesive pad on the back of the receiver.
Hold the receiver so the small cylinder is near the
lower edge of the receiver and is facing the Console
Back as shown.
Firmly press the receiver onto the indi-
cated corner of the Access Door (94). Note: If there are
two screws included with the chest pulse sensor and two
plastic posts on the inside of the Access Door, attach the
receiver to the plastic posts on the Access Door with the
two screws.
A
95
94
Cylinder
6
Wire