11
9. With the help of a second person, hold the con-
sole assembly near the Right Upright (83) and
the Left Upright (not shown).
Connect the Upright Wire (85) to the console
wire.
See the inset drawing. The connectors
should slide together easily and snap into
place.
If they do not, turn one connector and try
again.
IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Remove the wire tie from the
Upright Wire.
Console
Assembly
9
Console
Wire
Wire
Tie
85
83
85
Console
Wire
8. Set the console assembly face down on a soft
surface to avoid scratching the console.
Identify the Right Handrail (79). Hold the Right
Handrail near the console assembly. Route the
console wire through the large holes in the top
and bottom of the Right Handrail.
Set the Right Handrail (79) on the Console
Frame (81). Start a 1/4" x 1/2" Screw (8) with a
1/4" Star Washer (12) into the Right Handrail.
Then, start two 5/16" x 1 1/2" Bolts (4) with two
5/16" Star Washers (9) into the Right Handrail.
Make sure that the console wire is not
pinched. Start the Screw and both Bolts, and
then tighten them.
Attach the Left Handrail (not shown) as de-
scribed above.
Note: There is not a wire on
the left side.
79
Console
Assembly
4
8
12
9
81
8
Console
Wire
