ProForm PFRX31071, Руководство пользователя

Страница: 6 / 13

6
1. Feed the Recline Shock (20) and the attached cable
between the tubes on the Base (1).
See the inset drawing. Remove the rubber bands
from the screws in the Base (1). Be sure that the
Arm Brackets (31) inside the tubes on the Base are
pressed against the indicated sides of the tubes.
Align the posts on the Right Armrest (5) with the
tubes on the Base (1). Slide the Right Armrest onto
the Base.
Make sure the posts go inside the
tubes on the Base. Make sure the cable is
between the posts. Note: You may need to flex
the posts away from the Right Side Shield (7) to
assemble it past the Bracket Screws (see step
4) in the Base.
2. Tip the chair onto its right side. Remove the shipping
bracket from the Seat Frame (2) and the Back
Frame (4) by removing the Cotter Pins (26) and
Hairpin Cotters (27).
Save the Cotter Pins and
Hairpin Cotters; you will need them for step 3.
3. Attach the indicated end of the Recline Shock (20)
to the Back Frame (4) with a Cotter Pin (26) and a
Hairpin Cotter (27).
Attach the other end of the Recline Shock (20) to
the Seat Frame (2) with a Cotter Pin (26) and a
Hairpin Cotter (27).
Make sure that the cable is
under the Recline Shock, as shown in the draw-
ing. Note: You may need to raise the Back Frame
(4) to the upright position in order to attach the
Recline Shock.
Lift the chair back onto its base.
2
27
Shipping
Bracket
2
4
27
26
26
Place all parts of the massage chair in a cleared area and remove the packing materials. Do not dispose of the
packing materials until the massage chair is fully assembled.
Assembly requires only the included allen
wrench.
26
2
4
27
26
27
20
Cable
1
5
7
Posts
1
20
Cable
3
1
31
31
Top View
Assembly