12
To use the manual mode of the console, see the
instructions below. To use a Smart program, see
page 14. To use a Heart Rate program, see page 15.
To use an iFIT.com CD program, see page 16. To
use an iFIT.com video program, see page 19. To
use a program directly from our Web site, see
page 20.
HOW TO USE THE MANUAL MODE
Turn on the console.
Make sure that the transformer is plugged in or
that batteries are installed in the console (see
assembly step 12 on page 9).
To turn on the console, press the On/Reset button
or begin pedaling. (The On/Reset button is the
button just above the large display.)
Select the manual mode.
Each time the console is
turned on, the manual
mode will be selected. If a
program has been select-
ed, reselect the manual
mode by pressing the
Program button repeated-
ly until the letters RPM
appear in the small display.
Begin pedaling and change the resistance of
the pedals as desired.
As you pedal, change the resistance of the ped-
als by pressing the Resi and – buttons.
There are ten resistance levels; level 10 is the
most challenging. Note: After the buttons are
pressed, it will take a few seconds for the resis-
tance to reach the selected level.
Follow your progress with the large display and
the small display.
The upper sec-
tion of the large
display will
show the dis-
tance you have
pedaled and the
numbers of calories and fat calories you have
burned (see FAT BURNING on page 22). The dis-
play will change from one number to the next
every few seconds. If you use the handgrip pulse
sensor, the display will also show your heart rate
(see step 5 on page 13).
The center of
the large display
will show the
elapsed time and
your pedaling
pace (in minutes
per mile). The display will change from one num-
ber to the other every few seconds. Note: When a
program is selected (except for Heart Rate pro-
gram 2), the display will show the time remaining
in the program instead of the elapsed time.
The lower sec-
tion of the large
display will show
your pedaling
speed, your ped-
aling pace (in rev-
olutions per minute), and the resistance level.
The display will change from one number to the
next every few seconds.
Note: The con-
sole can show
speed and dis-
tance in either
miles or kilome-
ters. The letters
MPH or KM/H will appear in the lower section of
the large display to show which unit of measure-
ment is selected. To change the unit of measure-
ment, first hold down the Program button for a few
seconds. An E (for English) or an M (for metric) will
appear in the lower section of the large display.
Press the Resi button to change the unit
of measurement. Then, press the On/Reset button.
Note: When the batteries are replaced, it may be
necessary to reselect the desired unit of measure-
ment.
The small display will
show your pedaling pace
(in revolutions per minute).
The indicator bar in the
small display will increase
or decrease in length as
you increase or decrease
your pedaling pace. Note:
When you use a Heart Rate program, the small
display will show your heart rate instead of your
pedaling pace (see step 5 on page 13).
4
3
2
1
Indicator Bar
Содержание Interactive Trainer GL125
Страница 24: ...24 NOTES...
