ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the parts
used in assembly. Assembly requires the following tools: The allen wrench included and your own
phillips screwdriver , mallet wire cutters and needle-nose
pliers .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (82) until the treadmill is in the position shown.
Insert one of the Extension Legs (103) into the treadmill
as shown. Make sure that the Thick Base Pad (97) is on
the indicated side. Note: It may be helpful to tip the
Uprights (82) in the direction shown by the arrows as you
insert the Extension Leg. To fully insert the Extension
Leg, it may be necessary to tap it with a mallet.
Insert the other Extension Leg (not shown) in the same
way.
Handrail Washer (92)–4
Handrail Bolt (89)–4
Long Screw (79)–4
Screw (101)–4
82
1
97
103
82
2. Refer to drawing 2a. If there are plastic ties in the Cage
Nuts (36) in the Right Handrail (85), remove the plastic
ties. Pull 5” to 6” of the Wire Harness (17) out of the Right
Upright (82). Route the Wire Harness through the bracket
on the Right Handrail and out of the indicated hole. If nec-
essary, use needle-nose pliers to grip the connectors on
the Wire Harness. Thread the included wire tie through
the indicated hole in the Right Handrail (85).
Refer to drawing 2b. Look into the Right Handrail (85)
and make sure that the Wire Harness (17) has been se-
cured to the side shown. Tighten the wire tie and cut off
the excess from the end.
Refer to drawing 2c. Insert the bracket on the Right
Handrail (85) into the upper end of the right Upright (82).
Hand tighten a Handrail Bolt (89) with a Handrail Washer
(92) into each side of the Upright as shown.
Attach the Left Handrail (23) as described above. Note:
There is not a wire in the left Upright (82).
17
23
92
92
85
89
89
82
103
17
85
36
82
Tie
2b
2c
2a
17
85
Tie
5
