6
5
53
113
Ties
5
4
4
87
5
5. Attach the end of the ground wire to the small hole in
the side of the right Handrail (4) with a Silver Ground
Screw (113).
Set the Console Base (87) on the Handrails (4). Thread
four 3/4” Screws (5) into the Handrails and the Console
Base. After you have started all four Screws, tighten
the Screws until they are snug; do not overtighten
the Screws.
Insert the Wire Harness (53) through the two indicated
plastic ties on the Console Base (87) and then through
the hole in the bottom of the Console Base.
3. Insert a Plastic Shim (9) into each side of the post on
the right side of the Base (38). Next, orient the Right
Upright (15) as shown, and insert it into the Base. Make
sure that the Wire Harness (53) does not fall into the
Right Upright. Be careful to avoid pinching the Wire
Harness. Note: If necessary, tap the Right Upright with
a rubber mallet until it is fully seated in the Base. If the
Right Upright cannot be fully seated, remove the outer
Plastic Shim and then insert the Right Upright.
Attach the Right Upright (15) to the Base (38) with three
1” Bolts (16) and three 1/4” Star Washers (2). Do not
tighten the Bolts yet.
Assemble the Left Upright (not shown) in the same way.
15
The holes must
be on this side.
53
9
16
2
3
2
38
16
4. Hold a Handrail Spacer (3) with the arrow between the
two holes pointing upward. Thread the Wire Harness
(53) through the upper hole in the Handrail Spacer.
Insert the Wire Harness into one of the Handrails and
out of the large hole. If necessary, use needlenose pliers
to pull the Wire Harness out of the hole.
Hold the Handrail Spacer (3) and the right Handrail (4)
against the right Upright (15). Attach the right Handrail
and the Handrail Spacer with two 3” Handrail Bolts (1)
and two 5/16” Star Washers (101) as shown. Do not
tighten the Handrail Bolts yet.
Attach the other Handrail (not shown) to the Left Upright
(14) as described above. Note: There is not a Wire
Harness in the Left Upright.
53
Large Hole
1
14
101
4
53
3
15
4
