5
5. Slide one of the Handles (13) onto the Right Leg
(4). Attach the Handle with two 1/4Ó x 1 1/2Ó Bolts
(20) and two 1/4Ó Nylon Locknuts (46).
Attach the other Handle (13) to the Left Leg (3) in
the same manner.
6. The decal shown at the right should be found in
the indicated location on the AIR WALKER XT.
If
the decal is missing, or if it is not legible, call
our Customer Service Department, toll-free, to
order a free replacement decal
(see ORDER-
ING REPLACEMENT PARTS on the back of this
manual). Apply the decal in the location shown.
7.
Make sure that all parts are properly tightened before you use the AIR WALKER XT.
4. Refer to figure 4a. Insert the reed switch down
through the hole in the monitor bracket.
Refer to figure 4b. Slide the Electronic Monitor
(47) onto the monitor bracket as shown. Press
down on the Monitor until it snaps onto the
monitor bracket.
Make sure that the reed switch
wire is not pinched between the Monitor and
the monitor bracket.
Refer to figure 4c. Insert the reed switch into the
Plastic Clip (51) as shown. Tighten the #8 X 1/2Ó
Screw (45). Note: If the Electronic Monitor (47)
does not function properly, refer to HOW TO
ADJUST THE REED SWITCH on page 8.
Fig. 5
4
3
13
13
20
46
Fig. 4a
47
Monitor
Bracket
Monitor Bracket
Reed
Switch
47
47
Fig. 6
51
Fig. 4b
Fig. 4c
45
Reed
Switch
