13
If you purchase the optional heart rate monitor (see page 22), follow the step below to install the
receiver included with the heart rate monitor.
17.
Complete this step before you begin step 12.
Note: It will be necessary to reverse steps 15,
14, 13, and 12 if you have already completed
assembly.
Remove the paper from the adhesive pad on
the back of the Receiver (A). Press the Receiver
onto the indicated location on the inside of the
Rear Console Cover (80)
below
the Accessory
Tray (37).
See the inset drawing. Make sure that the
antenna on the Receiver (A) is oriented in
a horizontal position that is parallel to the
ground.
Connect the wire on the Receiver (A) to the
Extension Wire (162).
Next, attach the Rear Console Cover (80) with
four M4 x 16mm Screws (101).
Then, go to step
13.
Note: Discard any other wires that are included
with the heart rate monitor.
17
80
37
A
A
Antenna
101
162
101
4
