www.profitap.com
page 13
4. Unpacking and Installation
Unpack careful all items and retain packing material for later use.
XX-32G is shipped with the following items:
•
XX Main Unit
•
Swappable Module(s) (if purchased)
•
1x Power Cord & 1x Cat5 & 1x RS232 Cable, 2m ea.
•
Rackmount Set (not XX-32Gportable)
•
Quick Start Guide
Please contact your supplier if any part is missing or damaged.
Desktop or Rackmount of XX-32G
XX-32G can be placed on shelf or on desktop.
If required, XX-32G may be mounted into a 19” rack:
a) Slide the main chassis into the desired rack location
b) Secure the chassis using the supplied screws
c) Make sure the rack is grounded properly
For optimal & balanced thermal conditions the TAP and Module slot must be closed by filler strips in
case no TAP or Module is installed .
Connecting Power
Make sure to connect the redundant powersupplies to two separate,
independent power sources using the supplied power leads.
Make sure the mains powersources are grounded properly.
Note :
If powercords are connected to mains the unit will power up. It is recommended to continue in
unplugged condition and follow this manual up to Chapter 6 at first installation process before powering
up.
Mounting Connectivity Module
If the XX-32G is already equipped with a connectivity module check the
module for proper mounting prior of powering on the device.
If the Connectivity Module needs to be inserted first, follow this steps:
a) Remove the cover plate on the front by unscrewing the thumbscrews.
b) Slide in the Connectivity Module with the circuit board riding in the rails.
c) Push the Module firmly in its final position and the bezel is smoothly in match with the Frontpanel.
d) Secure the Module with the thumbscrews.
Note :
This Module(s) are swappable - you may exchange the module at any time under power, being
aware of data loss during the change.
