ProSear
Installation Instructions
Installation Of Your Indoor Grill
Your
ProSear
Indoor Grill is fully insulated and can be installed into standard wood cabinetry with zero clearance to
combustibles. The grill was designed to fit into a standard 30” base cabinet. A cut out of 29
"
x 20
"
is required in the
counter top. Combustible wall clearance must be maintained according to the specs on page 6 of this manual.
After cutting the recommended open-
ing in the counter top, remove the
Stainless Trim
on the grill & place
the grill into the opening and secure
the unit in place by screwing the four
counter brackets into the counter top
(Fig. A).
Then replace the
Trim
on
the grill and reinstall the 4 screws
(Fig
A1),
or install the
Heat Shield
(
Fig.
A2)
and the
Stainless Steel Trim
us-
ing the 4 screws that were removed.
Connect your gas line to the 3/8” pipe supplied with
your grill. A safety shut off valve must be installed
in an accessible location in the gas line external to
the appliance for the purpose of turning on or shut-
ting off the gas to the appliance (
Fig B and B1)
.
Plug the female end of the electric power cord sup-
plied with your unit into the electrical jack located at
the bottom of the control panel. Plug the male end into
a grounded 120V,60H 15 Amp receptacle
(Fig. C)
.
WARNING:
After the installation is complete, the Indoor Grill & all gas connections must be checked for leaks. See
Page 6 for Leak Check Instructions.
WARNING:
This appliance is equipped with a three prong grounding plug for your protection against shock hazard and
should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.
WARNING:
Your electric socket should be checked for proper polarity. Improper polarity can cause an electric shock
and serious personal injury.
Fig. A
Fig. A1
The Indoor Grill is designed to fit into a standard 30”
base cabinet. Your cabinets
CANNOT
have a center
door support as this would block the drip pan which is
located in the center of the grill
(Fig. D)
.
Fig. D
Fig. B
Fig. B1
Safety Shut Off
Fig C
↑
Drip Pan
7
Fig. A1
Fig. A2
Stainless Steel Trim and Heat
Shield Installation.
See page 6 for combustion clearances
when using heat shield or not using.
Gas Safety Shut Off
Electrical Jack Location
Drip Pan
