PROFIHOPPER 4WDi, Руководство по эксплуатации и техническому обслуживанию

Страница: 43 / 88

Instrument panel and controls
Profihopper PH4WDi BAF0012.0 02.13 43
6.6
Roll-over protection
WARNING:
If the roll-over protection is upright, putting on the seat belt is strictly re-
quired!
With the roll-over protection upright, do not jump out of machines that are
tipping over!
When driving with the roll-over protection folded in, you do not have to
wear the seat belt!
The folding roll-over protection must be folded out and secured for all
trips with the machine (Fig. 6.6-1)
At low passage heights and during machine transport, fold down the roll-
over protection.
In this case do not use the seat belt. After passing through the obstacle,
fold up the roll-over protection again and fasten the seat belt.
6.7
Adjusting the seat
1. Back and forth
Turn the lever to the left (Fig. 6.6/1) and move the seat to the desired
position.
2. Seat back angle
Raise the above lever (Fig. 6.6/2) to adjust the angle.
3. Adjusting the seat suspension
The Seat has different suspension positions according to operator
weight – range 50kg to 150 kg (Fig. 6.6/3).
Soft (light weight) Turn the lever to the right.
Hard (heavy weight) Turn the lever to the left.
4 Safety belt
The seat is equipped with a safety belt. When the roll-over protection
is upright, always wear a safety belt. Do not jump from a machine roll-
ing over.
•
Insert both ends of the safety belt.
•
Tighten or loosen the safety belt until it is close enough on your body.
Press the red button on the buckle in order to release the safety belt.
The driver's seat has a safety switch that switches off the engine as soon
as the driver leaves the seat.
It takes less than 7 seconds to switch off.
If the seat suspension is too hard, ground undulations can trigger this
safety function (engine will sputter).