Profi Care PC-HL 3086, Инструкция по эксплуатации

Страница: 43 / 74

PC-HL3086_IM 18.06.20
43
Remote Control
NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
The range of the remote control is limited.
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.
Changing the Battery of the Remote Control
If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the battery compartment on the bottom of the
remote control by holding the lever inwards and pulling
out the battery compartment.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity.
3. Then close the battery lid.
Notes for Use
Connected Load
The appliance supports a power input of 1500 W.
CAUTION: Overload
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appli-
ance is too powerful.
• Do not connect any other powerful appliances to the
same electric circuit.
Safety Switch
Your fan heater features a safety switch that disconnects
the power supply in case the appliance falls over. The safety
switch prevents hazards caused by overheating.
CAUTION:
Place the appliance on a smooth, horizontal surface. Avoid
carpets in order to prevent failure of the safety switch.
NOTE:
As soon as the safety switch has been activated, the
appliance must be set and switched on again.
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Connect the mains plug to a properly installed isolated
ground socket.
Operating Buttons
The buttons on the appliance are sensor touch buttons. In
order to perform the corresponding function gently touch the
buttons. Whenever a button is pressed, it will be confirmed
by a beep sound.
Control
Panel
Remote
Control
Function
TEM.
UP
Increase temperature
DOWN
Decrease temperature
TIMER
TIMER
Time-delayed switch-off:
to hours
SWING
SWING
Switch oscillation on / off
MODE
ON / OFF
MODE
Power level selection
( Fan , Low and High )
ON / OFF
Switching the appliance on / off
NOTE:
In order to switch off the appliance using the button
MODE ON / OFF on the front, repeatedly press the button
until the Fan indicator lamp starts flashing. The display
shows and indicates the activated 30 second timer.
Operation
NOTE:
• The operation is explained using the buttons on the
remote control.
• The buttons can only be pressed once the appliance
has been switched on by using the ON / OFF button.
Switching the Appliance On / Off
• Use the on / off switch on the back to switch on the
appliance. To do this, set it to position I . You will hear a
signal tone.
• Start the appliance using the ON / OFF button.
The appliance activates the fan mode and starts op -
erating in setting 1. Both the indicator lamp above the
MODE ON / OFF button and the Fan indicator lamp start
to light up.
• Press the ON / OFF button again to switch off the
appliance.
NOTE:
A 30 second timer will start in the display. During this
period the fan remains in operation to cool down the
appliance. The Fan indicator lamp is flashing. When
the timer period has lapsed, the appliance will auto-
matically switch into standby mode.