2
7) Never use oxygen
combustible gases, bottled
gases or high pressure
compressed gas as a power
source for this tool. The tool may
explode and cause serious
injury.
8) Dress safely. Protective
gloves and nonskid footwear or
safety shoes are recommended
when working with and operating
this tool. Don’t wear loose
clothing or jewelry. They can get
caught in moving parts. Also,
wear a protective hair covering to
prevent long hair from getting
caught in the tool.
9) Do not fire to hard materials.
Do not attempt to shoot toward
hard or brittle material such as
concrete, steel, or tile.
10) When operating tool, keep
the proper footing and balance to
avoid damage resulting from
losing balance.
11) Check damaged parts before
using the tool.
12) Replace parts and
accessories. Only allow
approved replacement parts.
13) Keep alert. Watch what you
are doing. Use common sense.
Do not operate any tool when
you are tired.
14) Store the tool. When not in
use, tool should be cleaned, fully
assembled and then, stored in a
dry location to reduce rust. For
safety, keep out of reach of
children.
15) Outdoor extension cord.
When air compressor is used
outdoors, use only rounded
jackets extension cords intended
for outdoor use.
16) Pay attention to the air hose
and their connections. Don’t trip
over hoses. Make sure all
connections are tight.
17) After loading the fasteners,
never point the tool at yourself or
any bystanders.
18) Use the correct air connector.
The connector on the tool must
not hold pressure when the air
supply is disconnected. If the
wrong fitting is used, the tool can
be charged with air after being
disconnected and still be able to
drive a fastener.
19) When connecting the air, the
tool can possibly fire the
fasteners. Therefore, remove all
the fasteners before connecting to
the air.
20) Do not depress the safe
bracket and the trigger when
loading.
21) If the fasteners are jammed,
disconnect the tool from the air
and remove the jammed
fasteners.
22) This tool is equipped with the
safe bracket that can adjust the
depth of the driver. When
adjusting the depth of the driver,
first disconnect the tool from the
air and rotate nut by thumb to
satisfactory position.
WARNING
The warnings,
cautions, and instructions
explained in this instruction
manual cannot cover all possible
conditions and situations that may
occur. It must be understood by
the operator that common sense
and caution are factors which
cannot be built into this product,
but must be supplied by the
operator.
SETTING
Your air tool is fully assembled
when you receive it. Before
using it, attach the air line and
desired air system accessories.
See figure below for the
recommended accessories and
connection order. Be sure the
air hose is depressurized when
installing or removing adapters
to the air line.
CONNECTING THE TOOL TO
AN AIR SUPPLY
1) Determine if the tool needs
oil and, if necessary, place two
drops of oil in the air plug. If you
are using an automatic in-line
oiler, check and add oil if
necessary.
