PROFAX PRO-1VS, Руководство пользователя

Страница: 10 / 28

PM 11 90
Installing Drive Rolls:
1 Drive Roll Securing Nut
2 Drive Roll Carrier
Turn nut one click until lobes of nut
line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
Cleaning Drive Rolls:
Remove drive rolls, and clean
grooves using a wire brush.
1
2
3
3-2 Installing Drive Rolls
FIGURE 3-1 Equipment Connection Diagram
Turn Off wire feeder and welding
power source.
Do not move or operate
equipment where it could tip.
Use only with CC/CV DC Power
Sources.
1 Constant Current (CC) or
Constant Voltage (CV) Welding
Power Supply
2 W eld Cable To Feeder
3 W ork Cable To W orkpiece
Weld cable and work cable connections
to power source (DCEN/ DCEP) are
dependant on wire type.
Since feeder is not polarity sensitive,
there is no need for an electrode
polarity switch.
4 W orkpiece
5 Voltage Sensing Clamp
Connect voltage sensing clamp to
workpiece.
6 Gun
7 Gun Trigger Receptacle
8 Wire Feeder
9 Gas Hose
10 Gas Cylinder
Use of shielding gas is dependant on
wire type.
Shielding gas pressure not to exceed
100 psi (689 kPa).
SECTION 3 INSTALLATION
CAUTION
READ SAFETY BLOCKS at beginning of manual before
proc eeding.
3-1 Equipment Connection Diagram
1
2
3
4
8 9
10
6
7
5
FIGURE 3-2 Installing Drive Rolls
3