1. Preface
1.1 Packing list
Product name
quantity
moving head light
1 pcs
Power -line
1 base
User manual
1pcs
1.2 Unpacking instructions
On receiving a fixture, carefully unpack the carton, check the contents to ensure that all
parts are presented, and have been received in a good condition. Notify the shipper
immediately and retain packing material for inspection if any parts appear damaged
from shipping or the carton itself shows, sign of mishandling. Save the carton and all
packing materials. In the event that a fixture must be returned to the factory , it is
important that the fixture should be returned in original factory box and packing.
1.3 AC Power
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or referred to the fixtures specification chart. A fixture listed
current rating is its average current draw under normal conditions. All fixtures must be
directly powered off a switched circuit and cannot be run off a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer source voltage matches the fixtures
requirement. Check the fixture or device carefully to make sure that if a voltage
selection switch exists that it is set to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line
voltage applied. Damage to your fixture may result if the line voltage applied
does not match the voltage indicated on the voltage selector switch. All
fixtures must be connected to circuits with a suitable Earth ground.
1.4 Safety instructions
Please read these instructions cy, it includes important information about the
installation, usage and maintenance of this product.
Please keep this user guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
Always make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal or rear panel of
the fixture.
This product is intended for indoor use only!
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure that
there are no flammable materials close to the unit while operating.
The unit must be installed in a location with adequate ventilation, at least 20in(50cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
Always disconnect from power source before servicing or replacing fuse and be sure to
replace with same fuse size and type.
Secure fixture to fastening device using a safety chain. Never carry the fixture solely by
its head. Use its carrying handles.
Maximum ambient temperature (Ta) is 104
℉
(40
℃
). Do not operate fixture at
temperatures higher than this.
10
