Manual: Orcabot XXL
Pro 2
version 1.0.1 Mar 2017
33
www.prodim-systems.com
8.
Calibration & Service
8.1.
Printbed alignment
The best 3D print results are achieved by aligning the bed as flat as possible. Follow below procedure
to align the bed if needed.
1.
Turn on the printer with the on/off switch at the right side of the printer.
2.
Go to menu and click on “Home All’ (zeroing all axes).
3.
Turn off the printer with the on/off switch at the right side of the printer.
4.
Manually set the left print head in the middle of the bed and move
manually the height of the bed with the knob on the bottom left of the
printer.
5.
Place the print head left (extruder 1) above the sunken screw visible through the glass bed.
6.
Take a white sheet of A4 paper and cut a straight piece.
7.
Place the paper piece on the bed and under the point of the nozzle.
8.
Move the bed manually in height with the knob under the print bed. See picture.
Turn the knob carefully till the nozzle has the right
height above the bed and the paper is on the
verge of being clamped.
The print bed is supported by springs which can be adjusted
to correct the height.
