Procon V3D Series, Руководство программиста

Страница: 60 / 88

H - I - J
PROGRAMMER’S MANUAL
V8.94.11-
- 60 -
Submenu Explanation, further submenus Values Default setting Unit
9-12
program 2.
The setting is the same as that of item 9-11 program 1.
●
●
●
9-25
program 15.
9-26
sequence 1.
Program group can be created by appointing any number of programs (programs 1 to 15).
On activating the sequence, the programs in the sequence run down one after another, according
to their priority. A running program in the sequence can be interrupted by a program of higher
priority or by a sequence of higher priority than that of the actual sequence. Also among the
sequences, the one with lower number has the higher priority.
9-26-1 activate
Setting the mode of activating the sequence.
disable
connect.
direct
by start disable
9-26-2 type
single: The programs in the sequence will be
performed once only, after that the
operation continues according to the
setting in menu item
9-26-5 .
cyclic: The programs in the sequence will be
performed cyclic until some inhibitory
condition prevents it.
e.g.- change of the activating input
- the cycle counter got to zero
- other input causes interruption
The cycle counter is always the counter
with the number identical with the given
sequence, if the sequence is of cyclic
type. In this case attention has to paid to
the right setting of the counter.
endless: The programs in the sequence repeat
continuously.
once
cyclic
endless once
9-26-3 error signal
At running the program, the time duration limit is
released by the decrease of the error signal below
the preset value.
N
0,01 - 100,00 N %
9-26-4 type
This refers to the input activating the sequence!
level: The sequence runs until the input is
active.
pulse: The sequence starts on pulse, and its
stop can be effected by the end of the
cycle, by the cycle counter or by a stop,
program inhibit etc. given from an input.
The time of the pulse has to be longer
than the bounce filtering time set in menu
4-9-5 .
level
pulse level
9-26-5 end
The event to be happen after finishing the program
or program group.
normal: Finishing the programs does not cause
stop command.
stop: Finishing the programs causes stop at
the same time.
normal
stop normal