Procom DGC-6D, Руководство по эксплуатации

Страница: 5 / 10

•
Load on EB (MCB)
•
Auto / Manual (Auto)
•
Emergency fault (Emer)
•
DG Fail to Start (FST)
•
DG Fail to Stop (FSP)
•
High Water Temperature (HWT)
•
Low lube Oil Pressure (LLOP)
1.2.4 Timers
Following timers are incorporated in the DGC-6D1I:
•
DG Start delay (variable)
•
Generator Voltage Supervision (variable)
•
Max. cranking time (variable)
•
Crank gap time (variable)
•
No of crank attempts (variable)
•
Mains restoration time (variable)
•
DG recooling time (variable)
•
High Water temperature (Variable)
•
Low lube Oil Pressure (Variable
•
Generator over speed delay timer (Variable)
•
Timer for stop solenoid (Variable)
1.3 Function
Auto/ Manual mode selection:
Press A/M button for 4 sec. On pressing the button the unit selects Auto or
manual mode. Auto LED glows when the unit is in auto mode. LED turns off I
manual mode.
Auto Mode
DGC-6D monitors the Mains supply, if Mains supply varies beyond set limit of
Under and Over voltage for more than Mains supervision time, DGC-6D starts the
genset.
To start the genset DGC-6D gives a cranking signal via potential free contact to
crank motor. On detection of engine start, started either by external engine start
input or by build up of generator voltage, the Crank command is withdrawn.
Max duration of crank command is user settable.
The maximum number of cranks is user programmable. Failure of starting of
generator after maximum-programmed crank attempts, result into blinking of FST
LED, indicating Fail to Start fault and the hooter is switched on.
While the genset is running, DGC-6D monitors the genset for external fault
LLOP, HWT, Emergency and voltage healthiness.
On detection of any fault, Gen-set is stopped by the DGC-6D after set time delay
& hooter is switched on.
On restoration of healthy EB supply for the set time duration the Gen-set is
stopped after recooling it for the user set recooling time.
Load change over is automatically performed by DGC-6.
Cat/DCG-6D1I/07-08/03/Ver 1 Page 5/10