www.usaprocom.com
200498-01A
4
ASSEMBLY INSTRUCTIONS
Follow the instructions below that best de-
scribes your fireplace.
Masonry With Glass Doors
1. Loosen clamps that hold glass door frame
to fireplace. Slide the mounting brackets
(E) behind the glass door frame (see
Figure 5). Place mounting brackets near
ends of horizontal glass door frame.
Note: If frame is too tall, the bottom of the
mounting bracket will not slide under the
linter (top) of the fireplace. If so, cut mounting
bracket off at point "Y" (see Figure 6).
2. Slide mounting bracket (E) into glass door
frame (see Figure 7). Tighten glass door
lintel clamps. This will secure the mount-
ing brackets.
3. Slide the fireplace hood assembly (A) over
the mounting brackets (E). See Figure 8.
INSTALLING HOOD TO MASONRY FIREPLACE
Figure 5
Figure 6
Figure 7
Figure 8
E
Glass
Door
Frame
Bottom of
Mounting
Bracket
E
Masonry Without Glass Doors
1. Tape the mounting brackets (E) near
the ends of the fireplace opening. Make
sure to position mounting brackets (E) as
shown in Figure 9. Mark screw locations
on fireplace lintel (top) through the slots
on the bottom of each mounting bracket
(E) as shown in Figure 9.
2. Remove mounting brackets (E) and drill a
5/32" diameter hole into the fireplace lintel
at each marked location.
