Part Data Memory (Partmaster)
- STORE PARAMETERS? YES / NO
When you wish to enter data for the selected part number the first time. Please note that
this is only permitted while the unit runs in AUTO mode. Normally, you want to memorize
data only after the part has run and performed well for a certain time (tooling run-in,
machine warmed-up, consistent material, etc.)
- OVERWRITE PARAMETERS? YES / NO
When you wish to refresh an existing set of data for the selected part number. This may
be the case when you have found better settings during a run or repeat run of that part.
Re-activating a previously produced part will do the following:
- reset all relevant parameters back to the settings of the previous run
- show you the former target force curves and your current forces (optional function)
- give you the load distribution diagram (old and new peak loads in comparison; optional function)
To see the target force curves versus your current forces press the TOOL function key. The graph
shows channel by channel (or in multi-channel presentation) how your current forces (blue lines)
compare against the memorized target area (gray envelope zone).
To see the load distribution diagram press M for Menu and then 6 for “Machine Loading Profile”.
Tool Performance / Target Force Curves
Shows the current force curve (in blue) vs the memorized
target forces from a previous run (stored on 31.05.2001).
The example here shows that channel number 2 is currently
working at much less load than before (peak force reading
now is 2290 vs. 3447 earlier).
Press the Curve function key to see the target curves
for all channels on one screen.
Machine loading profile
Shows for each channel the current peak force readings
(blue bars on the right side) vs the memorized previous
readings (green bars on the left side).
Target curve of 31.05.2001
Target curves
SK 7
V5.2 E 10/04
SK7-33
