12
3
a m p
channel power amplifier
p o w e r
PR O C E E D
2
a m p
channel power amplifier
p o w e r
PR O C E E D
2
1
Front Panel
1
POWER BUTTON
Pressing the latching
power
button connects the amplifier to the AC
mains, turning it
on
. Power consumption when fully on and at idle is ap-
proximately 140 watts for the AMP 2 and 210 watts for the AMP 3.
At your option, you may also toggle the AMP between a
standby
mode
and fully
on
by connecting its
remote turn on jack
to the corresponding
remote turn on output
on a Proceed control unit such as the PAV, PRE, or
even the CDP. Power consumption in
standby
mode is extremely small—
just a few watts for the circuitry which controls the turn-on procedure.
Note that if the amplifier has been disconnected from the AC mains
power by depressing the front panel
power
button, it cannot respond to
a remote turn-on command from a control unit.
2
INDICATOR LIGHT
The
indicator light
glows either amber or red, depending on the opera-
tional status of your AMP. Amber indicates that the AMP is
on
and ready
to be used. When the indicator light is glowing red, the unit is in
standby
(see 1 above). If the indicator light is completely off, the ampli-
fier is not receiving power. Check your AC connections and the rear-
panel AC fuse.
Содержание AMP2
Страница 1: ...PR O C E E D AMP 2 AMP 3 Power Amplifiers...
