Manufactured by ProBuilt Professional Lighting, LLC: 877-707-0800
IMPORTANT SAFETY INSTRUCTIONS
WARNING !!!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for Wobblelight® portable job site lighting. Before
using Wobblelight®, please review all of the following safety instructions carefully and read all labels on the
Wobblelight® unit.
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO UV RADIATION AND
INJURY TO PERSONS:
WARNING:
To reduce the risk of fire, electric shock or injury to persons:
•
DO NOT connect Wobblelight® to a power source unless the unit is completely and properly assembled.
•
LED arrays may get EXTREMELY HOT immediately upon illumination and can cause burns.
•
LED arrays can stay hot for an extended period of time after the Wobblelight® V2 unit has been turned off,
and can continue to cause burns.
•
To avoid risk of serious eye injury from the intense light, do not stare at the LED array when it is illuminated.
•
Suitable for Wet Location Use (IP54 Rated)
•
For use only on GFCI protected circuits.
•
DO NOT operate the Wobblelight® V2 in a continuous and unattended manner for extended periods of time.
•
CAUTION: RISK OF ELECTRIC SHOCK. Do not use with an extension cord near water or where water may
accumulate. Keep unit at least 16 feet away from pools and spas. Keep plugs and receptacles dry.
•
DO NOT SUBMERSE. DO NOT USE Wobblelight® V2 where there is potential for excessive or continuous
exposure to moisture from rain, snow, ice, water spray or standing water.
•
Connect Wobblelight® only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit
interrupter (GFCI) and over-current protection which is rated no higher than 15 amps. Any other connection
voids warranty.
•
DO NOT attempt to remove or replace the protective lens unless the Wobblelight® V2 unit is disconnected
from the power source and the LED array has completely cooled.
•
DO NOT operate the Wobblelight® V2 without the protective lens intact and secured the unit at all times.
•
Keep away from flammable materials.
•
DO NOT cover or attempt to seal the lens in any manner as this may restrict the internal air flow and
subsequent cooling effect on the LED array.
•
Wobblelight® V2 must be operated in the upright position only. DO NOT mount Wobblelight® units upside
down or restrain them such that they lay on their side.
•
Use only approved extension cords in good condition and of the appropriate type, gauge and length.
•
Keep extensions cord plugs dry and use ground fault circuit interrupter (GCFI) devices in accordance with all
applicable electrical code requirements.
Pg 2
