probst 5450.0006, Руководство по эксплуатации

Страница: 48 / 55

Maintenance and care 20 / 22
5450.0006 V1 GB
7.2 Trouble shooting
Fault Cause Remedy
The product slips
•
Gripper jaws/gripper claws are
worn out
•
Change gripper jaws/gripper claws
•
The load capacity is greater than
permissible
•
Reduce load capacity
•
The wrong gripping range is set
•
Adjust the gripping range to the
outer diameter of the product
•
The height support is set
incorrectly
•
Adjust the height support
according to the products to be
transported
•
The surface of the load is dirty
•
Clean the surface of the product
from dirt
•
The product is not suitable /
permitted for this device
•
Consult the manufacturer to
determine whether the product is
permitted for this device
The device is crooked
•
The device is loaded on one side
•
Focus on the product
•
The gripping range is not
symmetrically adjusted
•
Check and correct adjustment of
the gripping range
•
The height support is not set
symmetrically
•
Check and correct the height
support setting
SAFELOCK-Mechank does not work /
not correctly
•
Foreign bodies in the mechanics
•
Check for possible foreign bodies
in the internal gearing and remove
them
•
Dust or dirt in the mechanics
•
Clean the mechanics with high
pressure cleaner
•
Leg spring not hooked in
•
Hook in leg spring (e.g. with pliers
or screwdriver)
•
leg spring bent / broken
•
Replace leg spring (consult
manufacturer if necessary)
Load is not released
•
Hook-up eyelet is in the wrong
position of the scenery
•
Check the position of the
suspension eye in the splitter. To
release, the suspension eye must
be in idle position (position B,
marked red).
•
The dissolving power is not
sufficient
•
Correct angle for release. See
chapter Operation "Optimum
pulling direction for opening the
device".
•
Foreign bodies in the mechanics
•
Check for possible foreign bodies
in the internal gearing and remove
them