9
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
8
Visit
www.probrite.com/install
for installation video tutorials and product support
NOTE:
If photocell (B) is located in an area
under heavy shade the photocell may not
detect enough light and may turn the light
fixture on.
TIP:
To test if the light fixture (A) and pho-
tocell (B) works properly run power to the
fixture and cover the photocell to turn fixture
ON. Shine a light into the photocell to see if
fixture turns OFF.
OPTION 2: SWITCH CONTROLLED
Switch controlled operation enables the
light fixture to turn ON and OFF by flipping
a switch that controls the electricity to the
outlet powering the fixture. The light fixture
will not turn ON and OFF automatically, but
is manually controlled.
(Leave the black cap cover over the
photocell)
☐
To enable switch activated operation
leave the black opaque screw-on cap
(E) (comes pre-installed on the fixture)
on the photocell (B).
(Place clear cap cover on photocell
for Dusk-to-Dawn Operation)
☐
To enable dusk-to-dawn operation
remove black cap cover and ensure the
photocell (B) has clear cap cover (AA)
on it and is unobstructed.
☐
Ensure the switch powering the outlet
connected to the light fixture is turned
to the ON position and leave it ON
at all times to enable dusk-to-dawn
functionality to operate automatically.
A
Care and Cleaning
☐
Shut off main power supply before cleaning the product. To prolong the original ap-
pearance, clean the light fixture with clear water and a soft, damp cloth only.
☐
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐
Do not spray the light fixture with a hose or power washer.
SWITCH
CONTROLLED
Operation
1
Selecting Dusk-to-Dawn or
Switch-Controlled Mode
OPTION 1: DUSK-TO-DAWN OPERATION
Dusk-to-dawn operation enables the light fixture to automatically turn
ON when dark outside and turn OFF when the sun rises, thus saving you
energy.
AUTOMATIC
NIGHTTIME ON
DAYTIME OFF
Troubleshooting
Problem
Possible Cause
Solution
Light does not
turn ON
No power to the fixture
Check if circuit breaker is tripped
Confirm wall switch is ON
Verify wiring to fixture is correct
(turn power off to fixture
beforehand)
Fixture is sensing daylight
Cover photocell. Wait several
seconds until fixture turns ON.
Light cycles
ON and OFF
continuously
Photocell light sensor is
sensing reflected light
Relocate light fixture to a location
where there is no reflected light.
OR place the optional photocell
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light
FLICKERS
The light fixture is wired
through a dimmer switch.
Do not use a dimmer switch to
control the light fixture. Replace
the dimmer with a standard
ON/OFF wall switch.
E
A
AA
E
Swap
