9
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
8
Visit
www.probrite.com/install
for installation video tutorials and product support
☐
Once the fixture is installed, turn power
back on from the circuit breaker and
switch.
☐
Flip switch ON and OFF to ensure light
functions properly.
Care and Cleaning
☐
Shut off main power supply before cleaning the product. To prolong the original ap-
pearance, clean the light fixture with clear water and a soft, damp cloth only.
☐
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐
Do not spray the light fixture with a hose or power washer.
SWITCH
CONTROLLED
Operation
1
Turning lights ON/OFF
SWITCH-CONTROLLED
Switch-controlled operation enables the light fixture to turn ON and
OFF by flipping a standard light switch. To add automatic Dusk to
Dawn control or motion sensing external sensors like a photo-control,
motion-sensor or timer is required
(sold separately).
Troubleshooting
Problem
Possible Cause
Solution
Light does not
turn ON
No power to the fixture
Check if circuit breaker is tripped
Confirm wall switch is ON
Verify wiring to fixture is correct
(turn power off to fixture
beforehand)
Fixture is sensing daylight
Cover photocell. Wait several
seconds until fixture turns ON.
Light cycles
ON and OFF
continuously
Photocell light sensor is sens-
ing reflected light
Relocate light fixture to a location
where there is no reflected light.
OR place the optional photocell
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light
FLICKERS
The light fixture is wired
through a dimmer switch.
Do not use a dimmer switch to
control the light fixture. Replace
the dimmer with a standard
ON/OFF wall switch.
Light stays ON
Light sensor is in a shaded
area
Shine a flashlight into the light
sensor and wait a couple minutes.
If the light turns OFF, the fixture
should be moved to a location
with enough light in the daylight
hours for the light sensor to work.
OR place the optional opaque
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light Sensor is faulty
If the light does not turn off when
a flashlight is shined on the light
sensor for a few minutes, then
the sensor may be faulty. Please
contact customer service.
NOTE:
This fixture is not dimmable, so it
is best to not wire to a dimming switch.
NOTE:
Photocell (B) may have a few minute delay, to reduce it's
sensitivity to sudden light changes. When testing shine a light/cover
the photocell for a few minutes to check if fixture functions properly
