7
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
6
Visit
www.probrite.com/install
for installation video tutorials and product support
Installation (continued)
3
Remove the
mounting base plate
C
D
E
D
NOTE:
The mounting plate tightening screws
(C) comes pre-installed on the light fixture.
☐
Loosen the two mounting base
tightening screws (C) using a philips
screwdriver and remove the refractor.
☐
Remove the reflector from the base
plate (D) by loosening the two small
screws.
4
5
Knock out holes on
mounting base
Installing the mounting base
Installation (continued)
6
Making the electrical
connections
(fig 1b).
(fig 1a).
(fig 1).
(fig 1).
(fig 1).
(fig 2).
Junction box Mount
Junction box Mount
Surface Conduit Mount
☐
Route the junction box wires through
the large center hole in the mounting
base (D).
☐
Align the holes on the mounting
base (D) with the holes on your
junction box. Use two #8 screws (AA),
depending on the size of the holes in
your junction box, attach the mounting
base (D) to your junction box. (Fig. 1)
☐
Follow the wiring instructions
given below to make the electrical
connections. (Fig. 1)
☐
Mark and drill two holes on the wall
surface as per the desired location for
fixing the mounting plate (D).
☐
Use two or more suitable screws
(provided by others) applicable to
the surface of mounting and fix the
mounting plate (D) on the surface.
(Fig. 2)
☐
Refer to the guide in Fig. 1a to select
the holes to knock out or measure your
junction mounting holes and determing
proper knock-outs on the fixture's back
housing.
☐
Use a flat head hammer and screw
driver to knock out two holes in the
mounting base (D) in the desired
location to align properly with the
junction box. (Fig. 1b)
Small screws
Reflector
CAUTION:
DO NOT touch the LED and
Photocell lens (E) inside the fixture. DO NOT
damage or soil the reflector.
D
AA
Screws
(Provided by others)
