7
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
6
Visit
www.probrite.com/install
for installation video tutorials and product support
Installation (continued)
3A
3B
Installing Wall/Eave Mount Base
(Optional if desired)
Installing with Swivel Knuckle Mount
For mounting to domed junction box cover plate (sold
separately) or landscape post (sold separately)
C
NOTE:
The fixture comes with the knuckle
handle (Fig. 1) and the wall mount base plate
(C) is available separately within the box.
NOTE:
The fixture comes with the 1/2" threaded
NPS swivel knuckle mount (B) and is compatible
with standard domed junction box cover plates
with a center hole or landscape posts
Installation (continued)
(fig 1).
(fig 3).
(fig 2).
(fig 4).
Wall/Eave Mount Base Set Up on Standard Junction Boxes
For Ground and Wall/Eave Mounting
☐
Using allen key, remove the screw from
the center of the knuckle handle as
shown in fig. 2.
☐
Use the wall mount base plate (C),
provided separately in the box, and
thread wires through the hole of the
plate, being careful not to pinch the
wires.
☐
Place the fixture head in required
orientation with the plate and tighten
the screw on the knuckle which was
removed earlier. (fig. 3).
☐
Place wires through the hole in the domed
junction box cover plate or landscape post.
☐
Place tightening washer on back side of
domed cover plate.
☐
Screw 1/2" NPS threaded knuckle mount (B)
into the center hole of the domed plate or
landscape post and, if hole isn't threaded,
use tightening washer (G) to tighten fixture
into place.
☐
Use provided allen key (CC) to loosen
bolt in center of knuckle mount and select
desired angle. Tighten bolt to secure into
place.
Remove the
screw here
E
D
CC
4A
Removing the Mounting Plate from Wall Base
and Fixing it on the Wall/Eave
(Only Applicable for Wall/Eave Mount if using the base plate)
☐
Remove the mounting plate (D) from
the back of the fixture by loosening the
screws using the allen key (CC)(Fig. 1)
☐
Align the holes of the mounting plate
with the "TOP" marking oriented
upwards (or closest to wall if eave
mounted) with the junction box on the
wall and fix the mounting plate (D) on
the junction box by using the two #8
screws (AA). (Fig. 2)
Wall / Eave Mount using the base plate
Wall Mount
NOTE:
Use any other suitable bolts or fasteners
as applicable to your mounting surface.
AA
D
(fig 1).
(fig 2).
TIP:
Only unscrew the tightening bolt (E) far
enough to remove the mounting plate (D).
Do not fully remove the tightening bolt (E).
D
F
5A
Hooking Hands-Free Install Wire
(For install with Wall/Eave Mount Base Plate Only)
☐
Take the round "ball" head of the
hands-free wire (F), attached to back
of base plate, and place it behind the
bottom-center "notch" of the mounting
plate (D)
☐
Ensure the fixture can now hang-free
to allow for hands-free connection of
the electrical wires
Wall/Eave Mount
NOTE:
After electrical connections are made
un-hook the hands-free wire (F) and then
mount the fixture onto the mounting plate (D).
TOP
D
F
TOP
B
G
B
(Domed
junction box
cover plate)
(Landscape
post)
