10
EN
Ragazza
™
Troubleshooting Guide
Problem
Possible Cause
Solution
Boat does not respond to the
transmitter
Boat receiver is not bound to the transmitter
Bind the receiver to the transmitter
Low or no power
Replace/recharge batteries
Ensure connections are secure and powered on
Fouled or broken sails, lines or servo
Straighten, tighten or replace damaged parts
Boat moves too fast or too
slow for the wind and water
conditions
Rigging may be worn
Repair or replace damaged parts
Sails may be adjusted too tight
Loosen or adjust the sail rigging for wind and water
conditions
Steering rate incorrect on the transmitter for the wind
and water conditions
Adjust the steering rate
Vegetation or other obstacles block the rudder, keel
or sails
Remove vegetation or obstacles from rudder, keel or sails
Boat tends to turn one
direction
Sails are not centered
Center and adjust the sails and control lines for the wind
and water conditions
Rudder is not centered
Adjust or repair rudder, connectors or servo
Boat tends to drift
Sails are not centered
Center and adjust the sails and control lines for the wind
and water conditions
The rigging is worn or broken
Repair or replace damaged rigging
Rudder is not centered
Adjust or repair rudder, connectors or servo
Boat tends to dive in the
water or takes on water
Sails are rigged too high or low on the mast
Adjust the tightness of the rigging at the top corner and
bottom of each sail
Sails are tied too tight
Loosen lines
The boat hull is not completely closed
Dry out the boat and ensure the hatch is fully closed on
the hull before returning the boat to the water
Winch does not respond to
transmitter, while rudder does
Winch servo is disconnected
Connect servo to receiver
Winch, servo, line or other parts are blocked or damaged Repair or replace parts
Servo travel is too low
Adjust travel
Trim is incorrect
Adjust winch line or transmitter trim
Boat will not
BIND
(during
binding) to transmitter
Transmitter is too near boat during binding process
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Boat or transmitter is too close to large metal object
Move boat or transmitter away from large metal object
Bind button on the receiver was not pressed
Press and hold the bind button on the receiver
Low or no power
Replace/recharge batteries
Ensure connections are secure and powered on
Boat will not connect (after
binding) to transmitter
Transmitter is too near boat during connecting process Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Boat or transmitter is too close to large metal object
Move boat or transmitter away from large metal object
Boat battery/Transmitter battery charge is too low
Replace/recharge batteries
Transmitter may have been bound to a different model Bind boat to transmitter
Controls reversed
Transmitter settings are reversed
Perform the
Control Direction Test
and adjust controls
on transmitter appropriately
Maintenance and Repair
When parts are not repairable, see the
Replacement Parts List
to
order by item number. Refer to the list at the end of this manual for all
replacement and optional parts.
Apply CA (cyanoacrylate adhesive) to the end of a line to prevent fraying.
CA
