Recoil
®
17
Trim Tab Adjustment
Tip:
Ensure the trim tab panels are parallel to the bottom
of the boat.
You may desire to bend the trim tabs for wind and water
conditions. To adjust the angle of the trim tabs, use a large
pair of pliers to bend the tabs. This must be done carefully
so that you do not damage the hull.
Trim Fin Adjustment
NOTICE:
Carefully handle the sharp trim fins, which can
cause injury or damage.
1.
Loosen and tighten the fins on the mount using a hex
wrench and a pair of pliers.
2.
Adjust the turn fin angle so that the tip of the turn fin is
parallel but not lower than the keel of the boat.
Water Cooling System
If water does not stream out of the water outlets while
the boat is moving forward, immediately stop the boat
and clean the obstruction from the water cooling system.
1.
Disassemble and clean the water cooling system to
remove blockage and prevent overheating.
2.
Replace any damaged parts.
CH4
CH3
CH2
CH1
B/C
Failsafe
10
EN
Failsafe positions are also set during binding. In the
unlikely event that the radio link is lost during use, the
receiver will drive the servos to their preprogrammed
failsafe positions. If the receiver is turned on prior to
turning on the transmitter, the receiver will enter failsafe
mode. When the transmitter is turned on, normal control
is resumed. For more information on setting the failsafe,
refer to the Binding section above.
