WHEEL-E usage instructions
25
Figure 46: Brake lever equipped with brake sensor
with recuperation function during the braking pro-
cess
Note:
We recommend discontinuing acceleration via
the drive signal transmitter before operating
the brake lever equipped with the brake sen-
sor, . If you brake with this brake lever and
thus switch to recuperation while the drive
signal transmitter is still actuated, acceleration
will not be possible directly after releasing the
brake lever. First of all, release the drive signal
transmitter. You can then
accelerate again as
usual using the drive signal transmitter.
When driving downhill for longer periods, you
can keep the speed constant by switching on
the cruise control (Chapter 20.5.3; Fig. 40).
20.6 Lights
The basic equipment includes a
light set with
a separate rechargeable battery including a
charger
. The front lights are installed on the
front of the product and the rear lights are gen-
erally installed on the back cross bar on the
back of the coupled wheelchair. The lights are
switched on and off using the respective actua-
tion button on the lights.
Figure 47: Actuation button for the front lights
Figure 48: Actuation button for the rear lights
The
LED lighting set
can be selected as an
option. The front lights are installed on the front
of the product and the rear lights are generally
installed on the back cross bar on the back of
the coupled wheelchair. The front lights are run
off the drive system rechargeable bat-
tery/rechargeable batteries and are also
switched on and off using the drive system
display.
To switch on the front lighting, press and hold
for 3 sec. when the display is switched on.
Now the
symbol appears at the top centre
of the display. To switch off, press and hold
on the display again, for 3 seconds. Now
the
symbol in the display disappears.
Please note that the maximum range of the
product is reduced when the lights are
switched on.
Actuation button for the rear lights
Actuation button for the front lights
Brake lever with
recuperation function
