WHEEL-E usage instructions
24
While cruise control is activated, the speed can
be briefly reduced using the disk brake without
recuperation function. When you take your
hand off the brake again, the drive system
accelerates to the set speed again.
20.5.4 Reversing
To engage reverse gear, slide the switch on
the handlebar to the right position.
Figure 41: Switch on the handlebar to engage re-
versegear
Figure 42: Slide the switch on the handlebar (on the
left-hand side in the direction of travel) to the right to
engage reverse gear
Figure 43: Switch on the handlebar to the right;
reverse gear is engaged
Now the speed is controlled by pressing the
drive signal transmitter
downwards. In re-
verse gear, there is only one support level.
Figure 44: Press the drive signal transmitter down to
accelerate
Tetra gas actuation option:
If the product is
equipped with this option, you use the hand
rest to control the speed when reversing. To
accelerate, press the hand rest down. To re-
duce acceleration, reduce the pressure on the
hand rest.
Figure 45: Tetra gas actuation option
20.5.5 Recuperation (rechargeable battery
re-charging)
When the product is equipped with a hydraulic
disk brake, the
brake lever
with the brake
sensor is mounted on the right. When you
actuate this brake lever, support is automati-
cally interrupted and simultaneously switched
to recuperation mode.
Switch on the right
= reverse gear
engaged
Hand rest
Press down to accelerate