7.3
Press “set” button to select “F-C” mode
(see image below), press “set”button to
enter then press “up” and “down” button
to set F or C, C for celsius, F for Fahrenheit
4. Adjusting The Time
4.1
Once you have adjusted the
temperature, press the Mode Select
button again. “Time” lights and “set” lights
located in the display will illuminate
indicating you are in the adjust time
mode.
4.2
Next, press the (-) button located to
the bottom of the Mode Select button to
lower the value ,or press the (+) button
located to top of the Mode Select button
to raise the time value .The time setting
range can be set from 0~999.
5. Adjusting the Pressure
5.1
The Pressure Adjustment Knob is
located in the bottom of the lower platen
5.2
Adjust the pressure by turning the
knob clockwise to increase pressure and
counter clockwise to decrease pressure.
REMEMBER:
To allow for the thickness of
your garment when adjusting the
pressure.
6. Printing And Pressing
•
Once your equipment has reached the
designated temperature:
•
Position the garment and application
and proceed to press.Lower and lock the
heat platen into the press position.
•
This procedure will start the automatic
timing
•
The timer will automatically count down
circuit board will alarm when the press
cycle is complete.
•
The time will automatically re-set and
you are ready to continue with the next
application.
7. Changing From Fahrenheit To Celsius
7.1
Press and hold “down” and “up”
button then press“set” button,display
shows LCK
7.2
Input 68 to enter into second level
menu
