233(5$7,21,16758&7,216
1. Connecting the System
1.1
Connect the power cord into a
properly grounded electrical outlet with
a su
ffi
cient amperage rating.
1.2 VOLTAGE:
120 Volt – The GS-601
requires a full 20 amp grounded circuit
for 120 volt operation. 240 Volt –The
GS-601 requires a full 10 amp grounded
circuit for 240 volt operation.
1.3 EXTENSION CORDS:
If used, should
be as short as possible and not less than
12 gauge.Heavy duty cords are
recommended.
1.4 CIRCUITS:
that have less than 15
amps or that have other high demand
equipment or appliances(especially more
than one heat seal machine) plugged in,
should not be used.
CAUTION:
Failure to follow these
instructions will cause:
1. Erratic controller functions.
2. Inaccurate displays & slow heat-up.
3. The circuit breaker to disengage.
NOTE:
If the supply cord is damaged, it
must be replaced by the manufacturer,
its service agent or a similarly quali
fi
ed
person in order to avoid hazard.
2.1
Switch The System On
2. Turn On The System
3.1
Press the Mode Select button located
in the center of the Control Panel.
“Temp” lights and “set” lights located in
the display will illuminate indicating you
are in the adjust temperature mode.
3.2
Next, press the (-) button located to
the bottom of the Mode Select button to
lower the temperature setting,or press
the (+) button located to top of the Mode
Select button to raise the temperature
setting.The temperature can be set from
0° F (0° C) to 430° F (221° C).
3. Adjusting The Temperature