pg 4
Crossbow Set up
The Secure Band should
not
cover
the Transmitter light or
any portion above the light.
The Transmitter is designed to
break away from the Band upon
impact. Placing the Band higher on the Transmitter affects its
ability to break free when it hits the animal. Figure 10 shows the
correct placement.
IMPORTANT: You must make sure the hook is in the straight
up position of the arrow. A hook tilted right or left may ause
the arrow to drift and could cause injury to yourself or your
equipment. Never place your finger in front of the arrow or
Transmitter.
Figure 8
Figure 9
GOOD
Secure Band is nearly
butted up next to
the Clip
BAD
Secure Band too far away
from clip. Band NEVER goes
on or above Transmitter light
Figure 10
All crossbows shoot differently. The Retainer Clips and Secure Bands
require a different set-up based on your crossbow’s make and model.
Contact Pro-Tracker Archery or go to our website for correct set up.
The crossbow set up is the same as the compound set up, with
two exceptions: The O-Rings and the Secure Band.
After the clip
is resting against the Transmitter, slide on a black O-Ring. Its
function is to secure the Clip and Transmitter in place.
Screw on
your arrow, being sure not to over-tighten. (Figure 8)
You’ll then need to use the Secure Band to wrap around the
Transmitter and Carrier.
Correct placment of this Secure Band is
vital!
It must be wrapped around the transmitter as close to the
Clip without covering the Clip. (See Figure 9)
