PRO-PULSE PBN5018, Руководство по эксплуатации

Страница: 24 / 27

24
PBN5018
b
E
N
G
L
IS
h
25
!
!
!
!
!
!
CLEARING A JAMMED FASTENER
WARNING:
1. Disconnect the tool from the air supply.
2. Depress the lock to release the sliding magazine and pull the magazine out
fully.
3. Remove any remaining fasteners from the tool.
4. Use a slender, soft steel rod to push the drive blade to its uppermost
position.
5. Remove the jammed fastener with needle nose pliers.
6. If this is unsuccessful, it may be necessary to unscrew the hex socket head
bolts on the front of the nose piece.
7. Open the nose piece.
8. Sieze and pull out the jammed fastener with pliers.
9. Re-assemble the nose piece.
10. Follow instructions in LOADING THE FASTENERS to reload fasteners
SEALS
WARNING: Disconnect tool from air supply before attending to any tool repair.
„
When repairing the tool, the internal parts must be cleaned and lubricated.
Parker O-Lube or equivalent must be used on all o-rings.
„
Each o-ring must be coated with O-Lube before assembling.
„
A small amount of oil must be used on all moving surfaces and pivots.
„
After re-assembly, a few drops of 30W non-detergent oil or equivalent must
be added through the air line before testing.
SAFETY CONTACT TRIP MEChANISM
This may also be known as the WCE (Work Contact Element)
WARNING:
1. Disconnect the tool from the air supply.
2. Remove all fasteners from the magazine.
3. Make sure the trigger and safety contact move freely up and down without
sticking or binding.
4. Reconnect air supply to the tool.
5. Depress the safety contact against the work surface without pulling the
trigger. The tool must not operate.
WARNING: Do not use the tool if it operates without pulling the trigger. Personal
injury may result.
6. Remove tool from the work surface. The safety contact must return to its
original down position.
7. Pull the trigger. The tool must not operate.
WARNING: Do not use the tool if it operates without depressing the safety
contact. Personal injury may result.
8. Depress the safety contact against work surface.
9. Pull the trigger. The tool must operate.
WARNING: Repairs should be made by an authorized repair centre. Opening
this tool could invalidate your warranty.
NOTE: Due to continuous product improvement, we reserve the right to change
the product specifications without prior notice.
MAINTENANCE