pro.point Harris M, Руководство пользователя

Страница: 14 / 32

Harris Type Welder - Style M
14 For technical questions call: 1-800-665-8685
8345076 V 1.0
SAFETY GUIDELINE
DANGER
Danger means a hazard that will cause death or serious injury if the warning is ignored
WARNING Warning means a hazard that could cause death or serious injury if the warning is ignored.
CAUTION Caution means a hazard that may cause minor or moderate injury if the warning is ignored. It also
may mean a hazard that will case damage to property.
NOTICE Notice means any information pertaining to the product or its proper usage.
GENERAL SAFETY
WARNING Always keep an approved fire extinguisher accessible while performing
oxyfuel operations.
WARNING
Flying sparks and hot metal can cause injury. Take necessary precautions to reduce
the possibility of injury from flying sparks and hot metal.
Wear ANSI approved face shield or safety glasses with side shield protection when
chipping or grinding metal parts.
Wear ear plugs when welding overhead to prevent spatter or slag from
falling into ears.
WARNING Oxy-fuel operations product intense light and heat and ultraviolet (UV) rays. The
intense light and UV rays can cause injury to eyes and skin. Take all precautions
described in this manual to reduce the possibility of injury to eyes and skin.
All persons operating this equipment or in the area while equipment is in use
must wear protective welding gear including: welding goggles with a minimum
shade 5, flame resistant clothing, leather welding gloves, and full foot protection.
WARNING Oxy-fuel operations cause sparks and heat metal to temperatures that can cause
severe burns! Use protective gloves and clothing when performing any metal
working operation. Take necessary precautions to reduce the possibility of skin and
clothing burns.
Keep all clothing and protective equipment free of oil and grease. These substances
can ignite and are extremely volatile in the presence of pure oxygen.
Make sure that everything is protected from heat, sparks, and ultraviolet rays. Use flame
resistant barriers as needed.
Never touch work pieces until completely cooled.
WARNING There must be two (2) o-rings on the cone end. The absence of either o-ring can
lead to flashback within the torch handle or cutting attachment.
For cutting attachment, inspect the chamfered seating surfaces on tip and in torch
head. Have a qualified technician resurface the seat area if it has dents, burrs or is
burned. A poor seating surface may result in backfire or flashback.