V1.0
Wall-Mount Oscillating Fan
8975278
Visit www.princessauto.com for more information
7
locations using an appropriately sized drill bit as
recommended for the fastener.
6. Unscrew both screws in the fan’s support
bracket.
7. Slide the bracket onto the mount (Fig. 1).
8. Tighten both screws (Fig. 2).
9. Adjust the airflow upward or downward by
loosening the pivot nut (Fig. 1) and tilting the
fan, then tightening the pivot nut.
10. Remove all four screws from the motor’s front
housing and set aside (Fig. 3).
11. Separate the front and rear grill by removing
the security screw and opening the clips.
12. Position the rear grill so the bolt holes in the
center ring align with the motor’s bolt holes
(Fig. 4). Make sure the security screw bolt hole
is positioned at the lowest point.
13. Reinsert the four screws and tighten until the
rear grill is secure.
14. Loosen the collar screw on the fan blades.
Slide it onto the motor shaft until it is seated.
Tighten the collar screw to secure the blades
(Fig 5).
15. Place the front grill onto the rear grill and align
the bolt holes. Use the clips to hold the grills
together, then insert the screw and tighten.
16. The fan is ready for use.
OPERATION
1. Plug the fan directly into a properly grounded wall outlet.
2. Adjust the fan head’s tilt angle by loosening the bracket knob holding the
fan head to the wall bracket. Tighten the knob when the angle is correct.
3. The fan has three speeds and an OFF setting. Each pull of the right
string increases the speed setting one step from OFF, Low, Med, High
and back to OFF.
4. The left string will turn the oscillation ON or OFF with each pull.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
