pro.point 8843625, Руководство пользователя

Страница: 10 / 32

8843625 Air Needle Scaler V1.0
10 For technical questions call 1-800-665-8685
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool’s labels and name plates. These carry important information. If
unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CLEANING
Keep the tool clean. Wipe the tool with a clean cloth and periodically blow out all areas
with compressed air. If compressed air is not available, use a brush to remove dust
from all areas. Do not use harsh chemicals or solvents to clean the tool.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants are not
suitable and will damage the tool or cause a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool. Penetrating oil
acts as a solvent that will dissolve the tool’s grease packing and may damage
the o-rings, causing the tool to seize or malfunction.
1. All air tools have an internal coating of grease to prevent corrosion during
shipping and storage. Remove this grease by adding a generous amount of air
tool oil in the air inlet and then run the tool under no load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool’s male connector before
each use and after every hour of continuous use. The tool will not work properly
without lubrication and parts will wear prematurely.
3. Avoid adding too much air tool oil as this can cause premature power loss and
eventual tool failure. A qualified technician will need to take the tool apart and
clean out the excess oil.
4. Apply a generous amount of air tool oil to the tool before storing it for an extended
period of time (overnight, weekend, etc.). Run the tool for approximately 30
seconds to ensure the oil is evenly distributed throughout the tool. Store it in a
clean and dry location.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the steel parts
to avoid rust. Remove the lubricant before using the tool again.