7" Metal Cutting Circular Saw
10
For technical questions call: 1-800-665-8685
8380263
V 1.0
MAINTENANCE AND TROUBLESHOOTING
1. The brushes should be checked periodically and worn-out brushes should
be replaced. After replacing, inspect whether the new brushes can move
freely in the brush holder. Run the motor for 15 minutes without load to
shape the brushes, so that they are properly aligned with the commutator.
2. Keep the vent passage clear from dirt. Clean off the accumulated dust
and oil dirt periodically.
3. During normal operation, if anything happens, the power supply should be
cut off at once and the tool should be checked and repaired.
4. Clean the tool after each use.
5. In case of electrical or mechanical malfunction, immediately turn off the
machine and disconnect the plug. Ensure that the saw is unplugged and the
blade has stopped rotating before doing any maintenance.
6. Keep your Metal Devil Circular Saw and cord clean. Use only a damp cloth
and very mild soap to clean the saw.
7. Excessive sparking can indicate the presence of dirt in the motor or worn carbon brushes.
Check for wear. (fig.12)
8. For all other service and maintenance take the machine to an authorized service center.
9. Use only the flanges and washers that are supplied with the saw. Replace them with original (OEM)
10. When storing the tool, switch off the motor, unplug the cord from the power source and ensure that all moving
parts have come to a complete stop.
CAUTION: Only qualified service personnel should repair the tool.
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate recycling facility.
Fig. 12