![background image](http://html.mh-extra.com/html/pro-point/8354649/8354649_user-manual_1607341011.webp)
Visit www.princessauto.com for more information
11
8354649
V 3.05
5 in. Composite Air Angle Grinder
5. Use the handle to help steady tool and guide back and forth
over the workpiece in a steady motion.
6. When cutting avoid tilting the tool in the cutting plane.
Ensure the cutting wheel has a clean cutting edge.
7. To cut hard stone a diamond cutting wheel is recommended.
8. Do not use a cutting wheel for rough grinding.
9. After you are finished using the tool, turn it off. The disc will
continue spinning for a short amount of time. Do not put the
tool down until it has completely stopped moving.
10. If any of the following events occur during normal operation,
the tool should be shut off at once and thoroughly inspected
by a qualified person and repaired if necessary:
10.1 The turning parts get stuck or speed drops
abnormally low.
10.2 The tool shakes abnormally, accompanied by
unusual noise.
10.3 A burning or acrid odour is noticed.
10.4 The housing becomes abnormally hot.
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components.
3. Follow instructions for lubricating and changing accessories.
4. Keep the tool handles clean, dry and free from oil/grease at
all times.
5. Inspect the tool fittings, alignment and hoses periodically.
Have damaged or worn components repaired or replaced by
an authorized technician
.
6. When servicing, use only identical replacement parts. Only
use accessories intended for use with this tool. Replace
damaged parts immediately.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.